Snapper 2811523BV (7084940), Инструкции по безопасности и руководство оператора

Страница: 27 / 40

25
Maintenance
Battery
Battery Removal
1. Carefully pull each side of the battery cover (A, Figure
48) away from the ratchet fasteners (B) and remove the
cover.
2. Remove the hair pin and swivel from the deck support
to allow clearance for battery removal.
3. Slide the battery from the battery box to gain access to
the terminal cables.
4. Observe and note the cable positions (A and B, Figure
49) on the battery.
5. Disconnect the cables from the battery terminals, dis-
connecting BLACK (Negative) cable (A) first. Retain the
mounting bolts and nuts.
Battery Installation
1. Slide the battery partially into the battery housing.
2. Connect the red positive (+) cable
(B, Figure 49) first,
from the wiring harness to the positive terminal (+) on
the battery, using the bolt and nut provided in the hard-
ware bag. Connect the black negative (-) cable
(A) last,
to the negative terminal (-) on the battery, using the bolt
and nut. Apply a small amount of grease over the termi-
nals to prevent corrosion.
3. Reinstall the positive terminal insulator (C) .
4. Insert the battery completely into the battery housing.
5. Reinstall the battery cover
(A, Figure 48) .
6. Reinstall the swivel and hair pin for the deck support.
Maintenance (Continued)
WARNING
DO NOT attempt any adjustments, maintenance, service or
repairs with the engine running. Stop engine. Stop blade.
Engage parking brake. Remove key. Remove spark plug
wire from spark plug and secure away from plug. Engine
and components are HOT. Avoid serious burns, allow all
parts to cool before working on machine. Fuel Filler Cap
and Vent must be closed securely to prevent fuel spillage.
DO NOT attempt to service or charge the battery while it is
installed on the machine.
!
!
Figure 48: Removing the battery cover
A
B
CAUTION
If the battery is removed, DO NOT operate the engine
without insulating the Positive (+) battery cable terminal
with electrical tape, or sparking from the battery cables
can result.
!
!
WARNING
The cables must be connected to the battery terminals in
the proper position as shown. DO NOT attempt to charge
the battery while installed on the Rear Engine Rider. DO
NOT use “BOOST” chargers on the battery.
!
!
Figure 49: Connecting the battery
C
A
B