Pg. 3
www.snapav.com Support: 866.838.5052
SM-RBX-PRO-8-BLK Installation Manual
Using the Center Support Plate
Changing the Center Support Plate Position
Changing the Standoff Position
The center support allows for almost any mounting configuration
possible. Additional sections may be trimmed out using a pair of tin snips
for further utilization of mounted equipment.
In order to drive screws into the studs through the side wall of the the
VersaBox Pro, you will need to remove the center support plate first. You
may also rotate the standoffs so that the center support plate matches
the desired height.
1. Insert ¼” flat head screwdriver into the slot at the rear of the standoff
and twist. Pry upward to remove it. (A)
2. Drive screws, and/or rotate the standoff 180° if desired. (B)
3. Press the standoff back in with the screwdriver until it clicks into
place. (C)
4. Repeat for each clip.
Perforations for
wire management
or attaching
equipment
Using Knockouts
The knockouts on the top and bottom of the VersaBox Pro may be used
for installing low voltage rings or for outlet boxes. If an outlet box is
installed, it must be an old work, residential grade box with integrated
work supports to allow for secure mounting.
Note: Once installed, to ensure fire safety, the silicone grommets must
remain in the VersaBox.
•
When using these as wire guides, slit each grommet down the
middle in a “+” shape, never remove them.
•
When using these for conduit, cut the grommet for the exact size
and shape of the conduit so that it gives the conduit a tight seal.
Modules
The back wall of the VersaBox Pro has holes and knockouts stamped
into it on 6” centers to allow for easy structured can module installation.
Use a ¼” drill bit to open more of the knockout stamps as needed to
mount equipment.
Installing Equipment into the Strong VersaBox™ Pro
The center support plate allows for a variety of equipment configuration options. To accommodate equipment of different thicknesses,
the plate hinges can be reversed. The plate is also perforated so that it can be trimmed down in size, or used for securing modules
and wiring.
Experiment with the equipment configuration to determine the best installation method. For images of different configurations
of equipment installed in the VersaBox Pro, see the VersaBox Pro product page and Support Tab at www.SnapAV.com.
Compact Wattbox
You have the option to orientate the standoffs toward the front or rear
of the VersaBox Pro. These 2 different positions provide the platforms
with 4 different levels (1A, 1B, 2A, 2B), as illustrated. The strandoffs and
positioning of the Mounting Platforms effectively give you the option to
raise or lower the platforms to the desired height, up to being flush with
the front of the can.
1A
2A
1B
2B
Recessed
Front
Recessed
Rear
Raised
Front
Raised
Rear
1A
2A
1B
2B
B
C
A
