SNAP Networks Private Limited.
Errors Found During Learning:
Observe the transmitter front panel for the following errors.
a.
ERROR
1:
Blinking all source LED‘s and red status LED for 10 sec and
going to standby mode. This indicates that the MIC is not connected.
Wait until it goes to standby mode, Remove and connect the MIC
properly and Repeat the learning process.
b.
ERROR 2:
Blinking of red status LED and D2 for 10 sec and going to
standby mode indicates that, the MIC has damaged.
Select Source ‘6C’ and Repeat the learning process.
Still problem continues contact Violet3d technical support.
c.
ERROR
3:
Blinking of red status LED and D1 for 10 sec and going to
standby mode indicates that, the noise in the room is too loud for
learning.
Reduce the room noise by turning OFF Fans, AC, etc and Repeat the
learning process.
d.
ERROR
4:
Source Blue LED blinking indicates that, the learning
procedure did not complete successfully.
Repeat the learning process.
Note:
In case of any error explained above happens repeatedly, Please
contact your service center.
