4 of 11
Contents
The jacking beam is fully assembled and packaged to protect it from any damage that may occur
during shipping. Included are the following components:
- Jacking beam assembly
- Jacking beam keeper kit
Installation
1.
Position the jacking beam on the lift so that the rollers rest on the rails on the inside edges of
the runways. The pump side of the jacking beam should face outwards.
2.
Bolt on the keeper brackets using the supplied hardware in the keeper kit.
3.
The jacking beam must be connected to the air supply in order to operate. Install the ¼” NPT
90° elbow from the keeper kit on to the pump.
4.
Attach the recoil hose to the ¼” NPT 90° elbow.
5.
Attach the other end of the recoil hose to the air fitting on the side of the lift runway.
NOTE: Keep the air source clean and make certain that an air filter/oiler is used to keep
dirt out of the air motor. Failure to provide clean air may void manufacturers warranty.
