background image

 

 

Do not use water spray and steam to clean the appliance. 

Do not try repair the appliance on your own. If the appliance is out of order 
and it is not possible to repair it by means of given recommendations, unplug 

it, open the doors and call the service expert. Only a service representative 
can remedy all technical or construction faults. 

The appliance should be transported only in the vertical position; 

do not 

tilt any more than 30°. 

 The manufacturer will not be responsible for any damage 

of  the  appliance  that  results  from  non-compliance  with  the  instructions  for 
transportation. 

INSTALLATION AND OPERATING CONDITIONS 

Positioning: 

This  appliance  can  be  installed  in  a  dry,  well  ventilated  indoor  where  the  ambient 
temperature  corresponds  to  the  climate  class  indicated  on  the  rating  plate  of  the 

appliance. Do not use it in the cellar, unheated summer cottage during autumn and winter. 

WARNING! The appliance should not be operated in an unheated room or 

porch.  Place  the  appliance  away  from  heat  sources  such  as  kitchen 

stove/oven, radiators, or direct sunlight.  The appliance must not touch any 
pipes for heating, gas or water supply or any other electrical devices. 

Minimum distances from the heat sources:  

- from the electric gas and other ovens - 30 mm,  
- from oil or coal fired ovens - 300 mm,  

- from built-in ovens - 50 mm  
If there is no possibility of ensuring the above- mentioned 
distances, provide an appropriate insulation board. 

 

Do  not  cover  the  ventilation  holes  at  the  top  of  the 
appliances – it must be a good air circulation around the 

appliance.  There  should  be  a  gap  of  at  least  10  cm 
between the top of the appliance body and any furniture 

that may be above it. If this requirement is not followed, 
the  appliance  consumes  more  electrical  energy  and  its 

compressor may overheat. 

 

If the appliance is placed in a corner, a gap of at least 

60 mm must be left between the appliance body and the 

wall. External dimensions for installation 

 

 

The  appliance  must  stand  on  a  level  surface  and  must 

not touch the wall.  If necessary, regulate the height of 
the appliance by adjusting the levelling feet: by turning 

them  clockwise  –  the  front  of  the  appliance  rises,  by 
turning them counter clockwise – it comes down.  If the 

appliance  is  tilted  slightly  backward  –  the  doors  will 
close by themselves. 

Содержание WD35SM











Отзывы: