5
P R E P A R I N G T H E A P P L I A N C E F O R O P E R A T I O N
It is recommended to prepare the appliance for operation with a helper.
Remove package.
Lift the appliance away from foamed polystyrene base.
Tear off adhesive tapes. Remove the separate polystyrene part (transport protection) between
the rear of the device and condenser
–
metal grid (if available).
When positioning the appliance in chosen location, it will move more easily into position if you lift
the front a little and incline it backward, allowing it
to roll on its casters.
Remove all red-coloured parts from the shelves
(
fig. 2
). Tear away the red-coloured adhesive
tapes from the door trays
–
they are intended only
for the transport of the appliance.
NOTE. When you open the freezer compartment door a l ittle red packing detail will fall
out
–
IT IS FOR TRANSPORTATION PURPOSES ONLY.
Suitably dispose the packaging material.
Take two supports
1
from the bag and insert them into the
guides
2
at the top back part of the appliance.
P O S I T I O N I N G
Place the appliance in a dry, well ventilated room.
W A R N I N G !
The appliance should not be operated in an unheated room or porch.
Place the appliance away from heat sources such as kitchen stove/oven, radiators, or
direct sunlight.
W A R N I N G ! T h e a p p l i a n c e m u s t n o t t o u c h a n y p i p e s f o r
h e a t i n g , g a s o r w a t e r s u p p l y , o r a n y o t h e r e l e c t r i c a l d e v i c e s .
Do not cover the ventilation holes at the top of the appliances
–
it must be a
good air circulation around the appliance. There should be a gap of at least
10 cm between the top of the appliance body and any furniture that may be
above it (
fig. 5
). If this requirement is not followed, the appliance consumes
more electrical energy and its compressor may overheat.
If the appliance is placed in a corner, a gap of at least 224 mm must be left
between the appliance body and the wall so that the freezer compartment
door
can
be
opened enough to
pull out the frozen
product drawer.
The
appliance
must stand on a
level surface and must not touch the
wall. If necessary, regulate the
height of the appliance by adjusting
the levelling feet: by turning them
clockwise
–
the front of the appliance
rises, by turning them counter
clockwise
–
it comes down. If the
appliance is tilted slightly backward
–
the doors will close by themselves.
Содержание RF31SM
Страница 1: ......
