10
5.
Turn the bracket 6 including the small plastic plate through 180° and replace it on the
other side of the refrigerator, using the two screw holes adjacent to each other.
6.
Place the refrigerator door on a soft surface. Remove the hinge support 5 from the
underside of the door and fit the hinge support provided on the opposite side.
7.
Take out the covering caps and then remove the hinge support in the middle 4. Note
the small plastic plate underneath the bracket. Caution: Support the door.
8.
Take off the freezer door 3.
9.
Remove the lower panel 11 by lifting it up slightly.
10.
Take out the fi xing screws and remove the bracket 2 with its hinge bolt. Note the
small plastic plate underneath the bracket.
11.
Unscrew the hinge bolt, together with the washers, from the bracket, and fi t it into the
corresponding opening on the opposite side of the bracket.
12.
Remove the bracket 7 and replace it with the holding bracket 2 with its hinge bolt.
13.
Now install the holding bracket 7 in the previous position of the bracket 2.
14.
Take out the sealing plugs 8 from the partition separating the refrigeration and freezer
compartments and replace them in the openings on the opposite side.
15.
Take out sealing plugs 9 from the freezer door and replace it in the opening on the
opposite side.
16.
Place the freezer door onto the hinge bolt on holding bracket 2. Caution: Support
the door.
17.
Turn the holding bracket 4 with its hinge bolt and plastic plate through 180°.
18.
Replace the bracket bolt on the opposite side of the freezer door and secure it with the
screws.
19.
Replace the covering caps over the screw heads. Place the refrigerator door onto the
hinge bolt on holding bracket 4. Caution: Support the door.
20.
Re-insert the hinge bolt of the bracket 6 into the refrigerator door and secure it with
the screws.
21.
Fit the four covers C over the bracket and the openings.
22.
Remove the screw covering caps a.
23.
Take out the screws holding the door handles. Move the handle slightly towards the
side with the screw and then pull the handle off to the front.
24.
Fit the handles on the opposite side, using the fixing screws to secure them (note that
the screws need to go through the sealing plugs b). Push the sealing plugs provided
(b) into the now empty openings in the door and replace the covering caps (a) on the
screw heads.
25.
Take out the cover 10 from the lower panel 11 and replace it on the opposite side.
26.
Replace the panel 11 on the appliance.
Wait for about 30 minutes before it is connected to the mains. If the unit has been tilted
to more than 30°, wait for about 4 hours before re-connecting it to the mains
.
