9
DEFROSTING, CLEANING AND CARE
FREEZER COMPARTMENT gets defrosted automatically: it operates a frost-free cooling
system (No Frost). However, according to how often the freezer door were opened and
closed, and to - how warm products were placed into the appliance, the frost can
accumulate on walls of freezer inner liner and drawers. It is normal. But the thicker is the
layer of frost, the higher is a power consumption. In case if No Frost system had not
managed to evaporate the excess moisture and the frost layer has formed on, you should
defrost the appliance. To defrost the appliance, follow the steps in sequence:
•
WARNING! Turn the appliance off and pull the plug out of the electrical socket.
•
Remove foodstuffs from freezer compartment. The frozen foodstuffs will not warm up
too much while you are thawing the freezer compartment if you cover them with a thick
cloth and keep them in a cool place.
•
Leave door of freezer compartment open. When the frost melts, clean and wipe dry the
surfaces and fixtures of the freezer compartment.
•
Close the appliance door. Plug in and turn on the appliance.
REGULARLY CLEAN THE APPLIANCE!
Note: before cleaning the cooling device and its rear compartment part,
the device must be disconnected from the mains by unplugging.
•
Protect the appliance inner surfaces and plastic parts from fats, acids and sauces. In
case of accidental spills – immediately clean with warm soapy water or dishwashing
detergent. Wipe dry.
•
Regularly clean the hermetic gaskets of the doors. Wipe dry.
•
At least once a year clean dust away from the back part of the appliance body and the
compressor. A soft brush, electrostatic cloth or vacuum cleaner may be used for
cleaning.
•
DO NOT use detergents containing abrasive particles, acid, alcohol or benzene for
cleaning the appliance inner and outer surfaces. DO NOT use for cleaning cloths or
sponges that have coarse surfaces intended for scrubbing.
•
If the appliance is to be left switched off for an extended period, leave its doors open.
CHANGING THE OPENING DIRECTION OF THE DOORS
It is recommended that changing the opening direction of the doors should be done with a
helper. You will need two spanners No. 8 and No. 10 and a head screwdriver.
When changing the opening direction of the doors, YOU CAN NOT lay the freezer
horizontally!
Warning: Always disconnect the unit from the mains before any maintenance or repair
work is carried out.
Before you start, please note the following:
∙ Always ensure that the correct number of washers is used on all hinge bolts and screws.
∙ So that the doors can close tightly against the frame, take the utmost care that they are
properly aligned during reassembly.
1. Remove covers c from the inside of the housing and door and the upper bracket 6
together with the nut and washers and the gasket under the bracket. Remove the
refrigerator door.
2. Remove the bottom cover 1.
Содержание F 27FG
Страница 1: ...UPRIGHT FREEZER Instruction for Use F 27FG...
