7.
Remove the mounting screws (
2
)
from the door, separate the handle (
3
) and attach
it by screwing the screws into the holes on same side (handles are reinstalled in the
case of doors with an aluminum frame).
8.
Using the supplied washers and gaskets, attach the lower bracket (
10
) on the
opposite side of the cooler, but first attach the bracket axle to the door. Screw in
the bracket (
5
) on the opposite side of the cooler.
TRANSPORT
THE MANUFACTURER WILL NOT BE RESPONSIBLE FOR ANY DAMAGE OF THE
APPLIANCE THAT RESULTS FROM NON-COMPLIANCE WITH THE
INSTRUCTIONS FOR TRANSPORTATION.
•
The appliance should be transported only in the vertical position.
•
When being transported, the appliance should be protected from atmospheric
conditions (rain, snow, dampness).
•
The appliance should be firmly secured in place while being transported, to avoid
slippage or any shocks in the transport vehicle.
•
If the appliance was transported not vertically, it may be connected to the
mains after 4 hours at least. If this is not done, the appliance compressor
may fail.
WARRANTY SERVICE
IF YOUR APPLIANCE IS NOT WORKING PROPERLY, ASCERTAIN WHETHER YOU CAN
REMEDY THE CAUSE OF THE FAULTY FUNCTIONING OF THE APPLIANCE YOURSELF. If
you cannot solve the problem yourself, contact the nearest refrigerator service
representative by telephone or in writing. When making contact necessarily indicate the
refrigerator model and number . You will find this data on the product label, which is
glued to the wall of the refrigerator compartment
.
ENVIRONMENTAL PROTECTION INFORMATION
This symbol indicates that once the appliance is no longer needed, it cannot
be disposed together with other miscellaneous municipal waste. It should be
collected and eliminated separately, i.e. in containers specially marked with
this symbol in large-dimension rubbish collection areas. Full information on
where to submit the old appliance safety can be obtained from local
government authorities, the shop where you bought the appliance or the
manufacturer’s representatives.
If you decided to scrap the appliance, make it impossible to use in order to prevent
possible misadventure. Pull out the electric plug from the electricity supply socket and
then cut off the cord. Tear off the gasket. Break the door lock if any.
WARNING! Do not dismantle the appliance yourself. Pass it on to recycling
companies.
