15
TEMPERATURE ADJUSTMENT
When the appliance is connected to the mains for the first time, the electronic controller
will display the current temperature inside the appliance (hereinafter referred to as the
ACTUAL temperature). The temperature set by the manufacturer is +5 °C
.
The electronic controller will always display the actual temperature in the
refrigeration unit instead of the set temperature
.
NOTE.
The electronic controller displays a variable air temperature near the evaporator
and is used to control the refrigeration unit. I.e. the controller only displays the actual
temperature at one point, so
when storing products that are sensitive to
temperature changes
, it is recommended to use additional temperature measuring
devices for optimal temperature selection (arranged at different device heights).
The temperature control range is from -
2 °C to +10 °C
.
Fig. 2
1.
The display shows the actual temperature.
2.
Press
"up"
or
"down"
to activate the temperature setting. When the temperature
setting mode is activated, the selected temperature value flashes on the display.
3.
To set the temperature, select the desired temperature by pressing
"up"
(temperature
is warming up) or
"down"
(temperature is cooling down) once more.
4.
When the temperature is set, the value set on the display stops flashing after 30
seconds and automatically returns to the actual temperature display.
ALARM CODES
Alarm
code
Reason
Information
Comments
„Hi“
The air temperature
is higher than the
maximum allowed
"Hi"
flashes at the highest
temperature; if configured:
the signal relay is activated,
an audible signal beeps
Danger of high
temperatures
(function is activated
according to
customer's request)
„Lo“
The air temperature
"Lo"
flashes at the lowest
Danger of low
Short click:
various
functions: e.g. ECO (not
activated)
Back to Menu
Long press
:
Menu
Short click
: confirmation
of setting
OK
- turn on the
lights
Long press:
switch on the
device
On/OFF
Short click:
temperature
setting point, temperature
control up.
Long press:
ECO
Short click:
temperature
setting point, temperature
control down.
Long press:
defrosting
–
turn on defrosting
„dEF“
