148
| SMSEagle NXS-9700-3G
| User’s Manual
12.
First run:
./failover config VIRTUAL_IP_ADDRESS
This will setup your Virtual IP address for your cluster
13.
Then run:
./failover start
which will run the Failover service
14.
You can check device state with:
./failover status
15.
You can always disable service with:
./failover stop
Above commands have to be done on each device (node) of HA-cluster!
SNMP-
monitoring
Failover feature uses KEEPALIVED-MIB for SNMP monitoring.
EXAMPLE OF READING
DEVICE CLUSTER STATE
VALUE USING NET-SNMP LIBRARY
a) Command for reading the result value:
snmpget -v 2c -c public ip-of-smseagle .1.3.6.1.4.1.9586.100.5.2.3.1.4.1
Result:
KEEPALIVED-MIB::vrrpInstanceState.1 = INTEGER: master(2)
Comment: Current device state is
master
Содержание NXS-9700
