SMSC MediaLB, Руководство по оборудованию

Страница: 12 / 28

MediaLB Analyzer
Hardware Manual
Document Version: V2.0.X-2 Date: 2008-12-17
3.1.2 Trigger
Will be activated in a later version of MediaLB Monitor.
3.1.3 Ready LED
Color
of LED Status Description
Green On Indicates the MediaLB Monitor is powered and ready for
operation.
Shortly Indicates the MediaLB Monitor is booting. Blinking
Continuously Indicates booting cannot be completed. Refer to:
Possible reasons for a red Ready LED that is blinking
continuously.
Red
On Indicates an error is occurred. Refer to:
Possible reasons for a red Ready LED.
Table 3-1: Ready LED
Possible reasons for a red Ready LED that is blinking continuously:
Reason Action
OptoLyzer Suite is not yet started. Start OptoLyzer Suite.
MediaLB Monitor device is not yet
added in the OptoLyzer Suite. Add MediaLB Monitor device. Refer to the online help of
the OptoLyzer Suite for details.
Table 3-2: Red Ready LED Blinks Continuously
Possible reasons for a red Ready LED:
Reason Action
Set the ‘Memory Depth’ on tab ‘License/Memory/MOST
Speed’ to 100000 (default).
Use dedicated filters to focus only on the data of interest. If the PC runs too slowly to process
all MediaLB data the buffer will
eventually get an overflow. This
occurs after some seconds to minutes
(depending on the transmitted load).
Check the PC system requirements. Refer to the
OptoLyzer Suite’s online help.
User stops streaming of data by
clicking the Stop button of the
MediaLB Monitor device in the
OptoLyzer Suite. Click the Run button of the MediaLB Monitor device in the
OptoLyzer Suite.
MediaLB Monitor USB driver is not
installed or not loaded properly. Consider reinstallation of the OptoLyzer Suite.
Table 3-3: Red Ready LED
Hardware Manual Copyright © 2008 SMSC
Page 12