SMSC MediaLB, Руководство по оборудованию

Страница: 18 / 28

MediaLB Analyzer
Hardware Manual
Document Version: V2.0.X-2 Date: 2008-12-17
4 Active-Pods
An Active-Pod is a small device that is directly connected to the MediaLB Debug Header of the DUT. It
buffers the MediaLB signals and transfers them to the MediaLB Monitor without compromising the
signal integrity.
4.1 3-pin Active-Pod for Low Speed MediaLB Debug
Header
A 3-pin Active-Pod Low Speed has three connectors: two of them (
MediaLB Connector A
and
MediaLB Connector B
) are used for connecting the Active-Pod to the MediaLB on the DUT and one
Active-Pod Connector
, which is used to connect the Active-Pod by means of a special cable to the
MediaLB Monitor. The cable is part of the MediaLB Monitor USB delivery!
MediaLB Connector A
is a 10-pin male type, 2 mm pitch connector. It is placed on the front side of
the Active-Pod. This connector is used for connecting the Active-Pod by means of an extension
connector to the DUT.
MediaLB Connector B
is a 10-pin female type, 2 mm pitch connector placed on the bottom side of
the Active-Pod. This connector is used for connecting the Active-Pod directly (or by means of
extension connector) on dedicated connector on the DUT.
Status LED
MediaLB Connector B
Status LED
MediaLB Connector A
MediaLB
Connector A
Pin 1
Front View
Bottom View
Pin 1
Active-Pod
Connector
Rear View
Figure 4-1: 3-pin Active-Pod Low Speed - Connectors and Status LED
Hardware Manual Copyright © 2008 SMSC
Page 18