SMP ZINGO DU X-002/P, Руководство по установке

Страница: 60 / 60

ZINGO DU X-002
Appendix C Page 60
71) Attach the end cap of the Small Hanging Assembly (item 38) to the appropriate post end using 3 off M10 x 40
Resistorx bolts (item 51) and Shockproof washers (item 59). STEP 30
72) Attach the Small Hanging Assembly by connecting the Ground Fixing Chain (item 41) previously cemented
into the ground, to the swivel link in the lower end cap using 1 off Coupling Link (item 49). Remove all excess
links before connecting.
STEP 30
73) Insert and knock home with a soft hammer 3 off Protective Plugs (item 70) into the three outside holes in the
top of the Straight Leg - 1200 Deck (item 3). STEP 31
74) Place small register diameter of Telescope Spacer (item 44) into hole on bottom of Telescope Mounting
Bracket (item 43) and attach to the top of Straight Leg - 1200 Deck (item 3) using M10 x 65 Resistorx bolt
(item 50) and M10 Washer (item 59).
The bolt should be tightened up sufficiently to allow the unit to be
rotated with a reasonable force. STEP 31
75) Place the Telescope (item 42) the correct way round in the mounting bracket. Large hole to large hole and fix
in position using the Moulding Fixing Bolt (item 68) and the Moulding Fixing Sleeve (item 69). These should
be tightened up sufficiently to allow the unit to be tipped with a reasonable force. STEP 31
76) In all fixing positions on the steel work that have not been utilised, the protective plug should be removed and
the permanent black protective plug (item 70) inserted & knocked home with a soft hammer.
77) In all the unused pre-inserted holes in the legs insert and knock home with a soft hammer the black plastic
plug (item 72).
78) On all the Clamp Rings (item 46) that have not been attached to the legs using the M6 x 25 Resistorx bolt
(item 54) insert and knock home with a soft hammer the white plastic plug (item 71) into the appropriate hole.
5 POST INSTALLATION INSPECTION
CHECK CHECK

1 All fixings are tightened to there appropriate torque settings and have no protruding sharp
edges.

2 Paint work and polyethylene are not damaged. (Any making good should be carried out using
the procedure in the Inspection and Maintenance instructions).

3 Concrete foundations are secure.

4 Concrete has a water shed away from legs.

5 Adequate provision of impact absorbing surfacing and no trip points within the minimum space.

6 Ensure all unused fixing holes in steel work, pe-inserted holes in legs and unused fixing holes
in clamps have the correct plastic plug fitted.

7 Ensure that the Telescope can rotate and tip with some resistance.

8 Site is clear of all tools and rubbish.

9 Remove any warning signs.

ISSUE L 15-11-2010