Smittybilt XRC10, Руководство по установке

Страница: 22 / 34

Installation Manual
Troubleshooting
SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY
Motor does not turn on
Switch Assy not connected properly
Loose battery cable
Solenoid malfunctioning
Defective Switch Assembly
Defective Motor
Water has entered motor
Insert Switch Assy firmly to the connector.
Tighten units on cable connectors
Tap solenoid to free contact, applying 12 volts
to coil terminal directly.
Makes an audible clicking when activating.
Replace Switch Assy
Check for voltage at armature port with switch
pressed. If voltage is present, replace motor.
Drain and dry. Run in short bursts without load
until completely dry.
Motor runs too hot Long period of operation Let winch cool down periodically.
Motor runs slowly or
without normal power Battery runs down
Insufficient current or voltage Recharge battery by running vehicle’s engine.
Clean, tighten or replace the connector.
Motor runs but cable drum
does not turn
Clutch not engaged
Ensure lever is completely in “engaged”
position. If that does not work, contact
qualified technician to check and repair.
Motor runs in one
direction only Defective or stuck solenoid
Defective Switch Assy
Tap solenoid to free contacts. Repair or replace
solenoid,
Replace Switch Assy