4
φ
360
φ240
φ1
20
8-
φ
14
material: GB700: Q235
ASTM : A283GRC A306GR55
JIS : G3113-87 SAPH38
φ300
φ
360
φ1
20
φ300
thickness: 8m m
sup erficial treatm ent:antirust lacq uer
thickness: 12m m
sup erficial treatm ent:antirust lacq uer
p icture 4: p ressure p late
p icture 5: m o unting d isk
All fasteners of the installed components must be reliable and fastening to prevent
the harm due to loose. when mounting, the bottom of mounting base must be adjusted
to level condition, otherwise it would cause the drift of lamp.
Ground wire(color: yellow or green) must be grounded reliably, in order to ensure the
use of safety.
With installed problems, please contact with the manufacturer before construction.
Mounted steps
1. according to picture 1 and picture 2 in the operation instruction, drill four Ф16mm
holes on the floor plate with impact drill in determined place. pressure plate and
mounting disk must be tightened with screw M12 in the appropriate length, according
to picture 3.
2. According to mounted diagram, connect the rotating arm to the mounting plate,
regulate it to horizontal place, and tighten it according to picture 3.
3. Connect two balance arms to rotating arms respectively, and connect the
conductive plug. then tighten the two parts with the distributive screw.
4. According to the instruction for the balance arm of Ondal, link the conductive plug,
connect two lamps to the balance arms respectively, and make sure that it is reliable.
5. After careful examination and confirmation, debug the equipment with energizing
according to the operation instruction.
www.smitsonjupiter.com
