Smithco SweepStar 60, Запчасти и обслуживание

Страница: 11 / 60

Ser
vice
9
ADJUSTMENTS
SWEEPING
While sweeping close tailgate frequently to ensure tailgate does not creep open.
FILTER PACK
Filter pack may be cleaned by shaking or spraying off with low pressure water. Filter will disintegrate if high
pressure is used on it.
PARK BRAKE ADJUSTMENT
By turning knob on end of park brake lever you can tighten or loosen brake a small amount. To tighten turn
the knob clockwise. To loosen turn counter clockwise. If this is not enough turn clevis on brake cable to adjust
length of cable.
WHEEL 'CREEP' ADJUSTMENT
‘Creep’ is when engine is running and hydrostatic transmission is in neutral, but due to inadequate alignment,
wheels still move. Do the following procedures to stop this motion.
1. Lift up and support the unit so rear wheels are off the
ground and can turn freely.
2. On the side of hydrostatic transmission is the shift arm
(A) . In the ‘V’ shaped notch of shift arm rests and idler
pulley (B). This pulley is mounted on an idler arm (C).
3. Loosen bolt and nut holding pulley to idler arm. Leave
finger tight.
4. With engine running, slide the pulley in idler arm slot
until it centers on shift arm on hydrostatic and wheel
‘creep’ stops.
5. Tighten all fasteners and test by using foot pedal link -
age to see that the ‘creep’ is removed.
6. Turn the engine off and lower the machine.
STORAGE
When storing, remove the key from the key switch to avoid unauthorized persons from operating machine.
1. Before storing clean machine thoroughly.
2. Check bolts and nuts, tighten as necessary.
3. Make all repairs that are needed and remove any debris.
4. Remove the battery, adjust the electrolyte level and recharge it. Store the battery in a dry, dark place.
5. Store in a clean and dry area, but NOT near a stove, furnace or water heater which uses a pilot light or
any device that can create a spark.
6. Engines stored over 30 days need to be protected or drained of fuel to prevent gum from forming in a
fuel system or on essential carburetor parts. Check the engine manual and follow the instructions for
the storage of the engine.