Smithco Sprayer Star 3180 SmarTrax MD, Руководство по установке

Страница: 25 / 30

Manual No. 016-9002-003 Rev. A 21
Node and Wiring Installation
Install the Chassis Cable - SmarTrax MD-
Only Systems (If Applicable)
If the machine does not contain an existing chassis power system (such as AutoBoom, product control, etc.), it
is necessary to install the chassis power cable to operate the SmarTrax MD system. If a CAN system already
exists on the machine, refer to ,
Connect SmarTrax MD to an Existing Chassis Cable (If Applicable) below to
connect power to the SmarTrax MD system.
Note:
The chassis cable is sold separately. Contact your local Raven dealer or ordering information.
1.
Locate the SmarTrax chassis cable (P/N 115-4001-085).
2.
Connect the TO SMARTRAX NODE connector from the chassis cable to the round 16-pin connector on the
node harness (P/N 115-4001-157).
3.
Connect the TO CONSOLE CABLE connector to the Raven console cable.
4.
Install a terminator (P/N 063-0172-369) on the CAN cable connector.
5.
Loop and tie-off the REMOTE SWITCH cable connection, securing it with plastic cable ties as necessary.
Note:
The REMOTE SWITCH connector is not used in the SmarTrax MD system. Ensure the cable is
secured away from moving parts and heat sources.
6.
Connect the ring terminals to the battery.
Note:
The positive connectors are fused.
Connect SmarTrax MD to an Existing
Chassis Cable (If Applicable)
Note:
The SmarTrax interface tee is sold separately. Contact your local Raven dealer for ordering
information.
1.
Locate and disconnect the connection between the Raven console cable and chassis cable on the
machine’s existing CAN system.
2.
Install the SmarTrax interface tee cable (P/N 115-4001-070 or 117-4001-071) between the chassis and
Raven console harness.
3.
Connect the SmarTrax MD node harness (P/N 115-4001-157) to the remaining SmarTrax interface tee
connection.
Calibrate the SmarTrax MD System
Refer to the SmarTrax MD Calibration & Operation Manual (P/N 016-5030-020) for instructions on calibrating
the SmarTrax MD system, adjusting system settings, and system operation.