Smithco Spray Star 1000, Запчасти и обслуживание

Страница: 95 / 112

95
Accessories
10-378 FOAM MARKER PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 HNTL-38-16 Lock Nut,
3
/
8
- 16 2
HW-38 Flat Washer,
3
/
8
4
HB-38-16-300 Bolt,
3
/
8
- 16 x 3 2
2 20-723 RH Bracket 1
3 HB-14-20-075 Hex Bolt,
1
/
4
-20 x
3
/
4
4
HNFL-14-20 Flange Lock Nut,
1
/
4
-20 4
4 20-726 LH Bracket 1
5 10-645 Foamer Plate 1
6 HB-516-18-075 Bolt,
5
/
16
- 18 x
3
/
4
4
HW-516 Flat Washer,
5
/
16
4
HNFL-516-18 Flange Whiz Nut,
5
/
16
- 18 4
7* 14-291-04 Tank Bracket 2
8* 14-291-02 Foamer Tank 1
9* 14-291-03 Compressor Only 1
14-291-01 Black Cover 1
10* 14-284-02 Cap Assembly 1
11* Clear Tube 1
12* Blue Tube 1
13* 14-291-05 Double Switch Box 1
33-508 Auto Blade Type Fuse 15amp 1
15-506-02 Switch - middle 1
14-291-14 Switch - outside 1
14 8803-6 Black Trim 1
* 14-291 Foamer
(includes parts 7-13)
1
INSTALLATION
HOSES
Being careful not to cut the tubing, cut the over-sleeve back approximately 2" (5 cm) to expose blue and clear
tubing. Remove blue wing nut from top connector of foam nozzle and slide it on the blue tube with the threads
facing toward end of tube. Slide blue tube all the way over the top of the small tube on foam nozzle. Slide
wing nut back to the threads and hand tighten. Follow the same steps for the clear tube and tube nut.
Route the tubing along underside of main frame using tie downs as necessary.
Install opposite ends of air-liquid tubes to compressor, again cutting back the over-sleeve approximately 2" (5
cm) and inserting blue and clear tubes for the left boom section into the tubing connectors on the right side of
compressor as far as possible. Follow the same steps for the right boom tubing. Notice the right boom is in -
serted into left side of compressor. To release tubing from compressor, hold black ring around tubing, and pull
tube out.