Smithco 20-500-A, Запчасти и обслуживание

Страница: 9 / 106

7
Service
ADJUSTMENTS
WHEEL CREEP
"Creep" is when the engine is running and hydrostatic transmis-
sion is in neutral, but due to inadequate alignment, wheels still
move. Do the following procedure to stop this motion.
1. Lift up and support machine so rear wheels are off the ground
and can turn freely.
2. In the engine compartment, the hydrostatic transmission is
on the left side. The shift arm (D) is under the pump and
comes out the side. The idler arm (B) has a bearing that runs
in the notch of the shift arm. Loosen bolt (A).
3. With engine running, move bearing (B) so it centers on the
shift arm (D) and 'wheel creep' stops.
4. Tighten all fasteners and test by using foot pedal linkage to
see that 'creep' is removed.
5. Turn engine off and lower machine.
SPRAY PUMP WITH BELT
Located to the right of the engine. The belt should have approximately 1 /
2
" (13mm) of deflection in the center of
the top strand. Loosen and tighten the 3 /
8
-16 x 1 1 /
4
bolts located on the foot of the pump mount.
MASTER BOOM SWITCH (FOOT SWITCH)
The master boom switch, located on the left floorboard is used to override the master switch on the computer
console of the spray systems. By pushing down it will turn on/off the booms.
For the 440 System the Master
Switch on the computer must be off for the master boom control switch to work.
GROUND SPEED CONTROL (FOOT SWITCH)
The ground speed control does not work the same as an automotive type cruise. The ground speed control is
located on the center floorboard and is used to lock forward speed.
TO ENGAGE:
1. Flip rocker switch ‘On’ (green light).
2. Obtain desired speed with foot pedal.
3. Step on foot switch to lock speed.
4. Push foot switch again to disengage.
SPEED CALIBRATION NUMBERS
The speed calibration numbers for the Spray Star 2000 is 785.
SPRAY BOSS CONTROL (ORANGE)
Engages and disengages speed boss. Forward is engage and all the way back is disengage. When the lever is
engaged it sets a stop for the accelerator. The accelerator pedal must be used to maintain this speed. To adjust
speed use the knob on the end of the lever, counter clockwise increases speed
and clockwise decreases speed. Disengage the lever and you will have full
accelerator pedal range.
TAN KAGITATION
The valve to turn on and off the tank agitation is located on the front of the seat
panel, drivers right hand side.Turn valve handle down to turn on and turn back
up to shut off.