Smithco 20-500-A, Запчасти и обслуживание

Страница: 7 / 106

5
Service
MAINTENANCE
ENGINE OIL
Change and add oil according to chart below
based on air temperature at the time of opera-
tion. Do not overfill. Use a high quality deter-
gent oil classified "For Service SJ or higher"
oil. Use no special additives with recom-
mended oils. Do not mix oil with gasoline.
1. Use SAE 10W-40 API Service SJ or
higher motor oil.
2. For proper warranty, change oil every
500 hours or annually, which ever is first.
3. Oil level should be 2-2½" (5-6.4cm) from
top of the tank when fluid is cold. Do not
overfill.
4. After changing oil, run the machine for a
few minutes. Check oil level and for
leaks.
5. Always use extreme caution when filling hydraulic oil tank or checking level to keep system free of
contaminants. Check and service more frequently when operating in extremely cold, hot or dusty condi-
tions.
6. If the natural color of the fluid has become black or smells burnt, it is possible that an overheating problem
exists.
7. If fluid becomes milky, water contamination may be a problem.
8. If either of the above conditions happen, change oil immediately after fluid is cool and find the cause. Take
fluid level readings when the system is cold.
9. In extreme temperatures you can use straight weight oil. We recommend SAE 30W API Service SG when
hot (above 90°F (33°C)) and SAE 10W API Service SJ or higher when cold (below 32°F (0°C) ambient
temperature. Use either motor oil or hydraulic oil, but do not mix.
10. Oil being added to the system must be the same as what is already in the tank. Mark the tank fill area as
to which type you put in.
TIRE PRESSURE
Caution must be used when inflating a low tire to recommended pressure. Over inflating can cause tires to ex-
plode. Front tires should be 20 psi (1.4bar) and rear tires should be 18 psi (1.3 bar). Improper inflation will reduce
tire life considerably.
WHEEL MOUNTING PROCEDURE
1. Set park brake. Turn machine off and remove key.
2. Block wheel on opposite corner.
3. Loosen nuts slightly on wheel to be removed.
4. Jack up machine being careful not to damage underside of machine.
5. Place wheel on hub lining up bolt holes.
6. Torque to 64-74 ft/lb (87-100Nm) using a cross pattern. Retorque after first 10 hours and every 200 hours
thereafter.
7. Lower machine to ground and remove blocks and jack.