Smith SPS10, Операция - Ремонт - Запчасти

Страница: 20 / 68

Operation
20 3A5578D
The DCS Control is now ready to grind/scarify. Long
press down on the Handlebar Rocker Switch to lower
the drum to your Cut Depth Target. Short press up or
down on the switch to adjust your Cut Depth on the fly.
When finished with your cut, long press up on the switch
to raise the drum to the Home position.
NOTE: The Zero Point and Cut Depth are referenced
from the Home position. Recalibrate your DCS Control
periodically by pressing the Home button or long press-
ing up on the Handlebar Rocker Switch.
NOTE: Pressing any button while the drum is moving to
Zero or Cut Depth will stop the command and halt the
drum from moving any further up or down until another
button is pressed.
Manual Height Adjustment
If the DCS Control is not usable (dead battery, etc.), the
drum height can be adjusted using the Manual Height
Adjustment feature.
1. Remove fuse from fuse holder near positive battery
terminal. This will protect the battery from damage.
2. Use a 6mm hex key to remove the screw plug on
the top of the linear actuator.
3. Insert 6mm hex key into the port the screw plug was
removed from.
- One revolution of the hex key results in 1/8”
(3mm, 125 mil) of adjustment at the cutter drum.
- Rotate counterclockwise to lower the drum;
rotate clockwise to raise the drum.
Max rotation
speed of 1 revolution per second. Do not
use power tools in the Manual Height
Adjustment port.
4. Once the desired depth is achieved, replace the
screw plug in order to keep water and dust out.