SMITH Manufacturing 1-954-941-9744 www.SmithMfg.com
LNX8
VERSION 2/2017
SMITH Manufacturing 1-954-941-9744 www.SmithMfg.com
MachINE start-UP
Do not start machine while drum is in
contact with the ground. Doing so can
cause the operator to lose control of the
machine, resulting in property damage
and/or personal injury.
NotE:
Do not attempt to raise or lower the cam
lever by force. If it does not move effortlessly,
raise or lower the hand wheel until the cam lever
can be adjusted. Before substrate removal, test
run the machine with the spindle or disk attached
not touching the surface. If there is excessive
vibration, you need to inspect the cutter head to
make sure nothing is missing and it is balanced.
Also check for bearing condition, and/or make
sure that the drive belt is not damaged.
If thE ENGINE doEs Not
start
1) Make sure the motor is plugged into the
electrical source.
2) Turn the Start / Stop switch (on the Starter
Box) to “Start”.
*Motor repair and engine warranty
issues are handled directly
by your local engine service center.
6
If motor does not start:
Try cycling the starter switch back to off before try-
ing to restart the machine.
If the switch is in a roughly 10 O’clock position
and slightly loose, the breaker was tripped; in this
case turn the switch to the “Off” position until it
clicks into place before attempting to restart the
machine. To restart the machine turn the switch to
“On”.
