SMITH Manufacturing
1-954-941-9744 www.SmithMfg.com
SMITH Manufacturing
1-954-941-9744 www.SmithMfg.com
VERSION 5/2014
FS150
5
RECOMMENDATIONS
ACCESSORIES
•
Recommended working pressure:
6.3 bar / 90 psi
•
Maximum working pressure:
7.0 bar / 100 psi
•
Recommended hose bore:
10mm / 3/8”
•
Recommended hose length:
10m / 30 ft
USING THE FS150
AIR SUPPLY:
Use clean lubricated air supply
that will give a measured air pressure at the
tool of
6.3 bar / 90 psi
when the tool is running
with the trigger/lever depressed. Use the
recommended hose size and length. Do not
connect the tool to the air line system without
incorporating an easy to reach an operate air
shut off valve. The air supply should be
lubricated. It is strongly recommended that an
air filter, regulator, lubricator (FRL) is used as
this will supply clean, lubricated air at the
correct pressure for the tool. Details of such
equipment can be obtained from your
supplier/dealer. If such equipment is not used,
the tool should be lubricated by shutting off the
air supply to the tool and de-pressurising the
line by pressing the trigger on the tool.
Disconnect the air line and pour into intake
bishing a teaspoon (5ml) of a suitable pneumat-
ic motor lubricating oil preferably incorporating
a rust inhibitor. Reconnect the tool to an air
supply and run slowly for a few seconds to
allow air to circulate the oil. If tool is used
frequently lubricate on a daily basis and also if
tool starts to lose power.
WORK STATIONS:
The tool should only be
used as a hand operated tool. It is recom-
mened that the tool is used when standing on a
solid floor. It can be used in other positions but
before any such use the operator must be in
a secure position having a firm grip and foot
-
ing and be aware of safety rules to be obeyed
when using the grinder.
•
FS200 Compact
Scarifier/Grinder
•
FS050 Handheld
Scarifier/Grinder
•
MV300 (110V)
HEPA Vacuum
