Edges of panel D and item #12 should
be flush as shown, check top and
bottom before fastening. Use of a
straight edge is recommended.
13. Place item #A-12 as shown. Confirm faces of panel D and item #A-12 align as show.
Fasten item #A-12 with the 5x fasteners #11-1.
14. Align edge of item #A-9 with the reference line as shown. Item #A-10 can be used as
a spacer for panel C. Insert panel C into the slot of item #A-12. Place item #A-9
against panel C as shown. Confirm that all 3x holes on item #A-12 and item #A-9 can
be seen though the slots while item #A-10 is in place. Fasten #A-12 and #A-9 to
panel C using 3x fastener #13-1 each. (Do not fasten item #A-9 to the panel T , this
will be done in future steps)
REVISED: 3/29/2022
Document #: 179719
Assembly Instructions
