Assembly Instructions
Document #: 179717
REVISED: 11/2021
REFERENCE LINES
PILOT HOLES
3. Place wood top on clean smooth surface upside down with the pilot holes and reference
lines facing up. The reference lines will be used to help align the metal components in future
steps, these are only guides final locations will vary by assembly accuracy. (Panel H is used in
these instruction, substitute panel H with panel E for 60” models)
4.
THE POSITION OF COMPONENT 3 IS CRTITICAL, IT DETERMINES ALL OTHER COMPONENTS
POSTIONS AND IS THE MOST DIFFICULT TO CHANGE AFTER THE ASSEMBLY IS DONE
. The outside
edge of item #3 vertical tubes should sit flush with the 3 indicated reference lines below.
5. Fasten item #3 down with 2x fasteners item #1 using the two pilot holes, confirm the location is
correct as described above and install the remaining 6x fasteners item #1.
Reference line
Reference line
Vertical Tubes
