9
10
smithandnoble.com
800.248.8888
Slide in End Cap onto rod and tighten
set screw.
End Cap can be attached with the
opening at the bottom or top depend-
ing on look you want to achieve.
If you want to get your drapery all the
way to the end of the rod, then place
opening of end cap at the bottom of
rod where track is.
If you want your draperies to stop
where the end cap starts, move the
open side of the end cap to the top of
track. The covered part of end cap will
be at the bottom where track is.
STEP 6 - ATTACHING THE FINIALS
STEP 7 - ATTACHING BRACKETS TO THE CEILING
Hold the rod up and attach the bracket to
the ceiling, aligning the holes of the brack-
et with the marks you made on ceiling on
a previous step.
Be sure and attach the bracket to the
ceiling with the appropriate mounting
hardware.
(It is always recommended to try and
attach to the ceiling joists found inside
ceiling. Where this is not possible please
use an anchor suitable to carry the weight
of your hardware selection as well as your
draperies and any accessories.)
Tighten the hex screw on the back of the
ceiling bracket to make sure the rod is
attached strongly to the bracket.
HEX
SCREW
CEILING
BRACKET
SPLICE
CONNECTOR
ROD
OPEN
END CAP FINIAL
COVERED
END CAP FINIAL
BACK OF ROD
BACK OF ROD
END CAP FINIALS
OPEN
COVERED
SLEEK
