Designed and developed by Proto Magic Innovations Ltd for SmitCare Copyright 2004-2014
Patents granted: GB 2404369 GB 2420551 Patents pending: GB1111539.1 GB1111537.5 GB1111536.7
6
Slatted Bed Installation
Note: Only one 2.5m brown strap is used
1. Remove the mattress from the slatted
base. Place the DreamMaster Light
frame centrally on the slats, with the top
of the frame 5cm (2”) from the head of
the bed. The cable for the motor should
lead up the bed, between the upper and
lower frame sections, or down through
the slats.
2. The width adjusting “trombone” needs
to be extended to suit the width of the
bed. Place the strap bracket on the
slats, with the curved side touching the
wooden side rail of the bed. Disengage
the trombone locking pin by pulling the
ring towards the head of the bed and
rotating a quarter of a turn. Now extend
the trombone until the inside edge is in
line with the upstand of the strap bracket.
3. Engage the trombone locking pin; this
may require minor re-alignment of the
trombone. Next, attach the strap bracket
to the elevator frame, ensuring that the
brown strap is able to fall freely between
the wooden slats. The metal strap buckle
may be moved along the slot to achieve
this. Repeat for the other side of the bed
then carefully place the mattress on top,
ensuring the elevator is not displaced.
If you are to use the DreamMaster Light
with the Knee-Break, refer to the Knee-
Break fitting instructions before you
proceed to point 4.
Trombone
Locking Pin
Trombone
