2
System Setup
Figure 2.4: FlashRunner Control Panel, File Transfer
Click the
“...”
button to browse for the image file to be send, then click
“Start”
to begin the transfer. The file will be saved to the SD card of the
selected programming module, in the
\BINARIES
folder.
9.
(Only for FR04A08 and FR04A16)
Next, we have to specify which of
available ISP sites (for the selected programming module, in this case
the first one) FlashRunner will use as output. To do this, send the
following command:
MXCLOSE 1
This will select the first ISP site, routing all of the FlashRunner’s ISP
lines of the first programming module to the target board through this
site.
10. We are now ready to start the actual programming part. Send the
following commands:
TPSETSRC FILE DEMO.FRB
TPSTART
TPCMD SETPWD CONST $FF $FF $FF $FF $FF $FF $FF $FF
TPCMD MASSERASE F
TPCMD BLANKCHECK F $EE00 4608
TPCMD PROGRAM F $EE00 $EE00 4608
TPCMD VERIFY F S $EE00 $EE00 4608
TPEND
24
