SMG Comfort Bilt HP50GC, Руководство оператора, Страница: 12 / 37

Operator’s Manual
HP50GC Pellet Stove
~ 12 ~
PREFERRED PELLET VENT TERMINATION CLEARANCE
● The stove vent must terminate on the outside of the building. Horizontal terminations must extend a minimum
of 12
”
from the wall. Vertical terminations must protrude a minimum 24
”
from the roof surface. In addition, all
clearances listed below must be met. SEE FIGURE 7
● Must have an approved cap (to prevent water from entering) or a 45° downturn with rodent screen.
●
If the termination is located on a windy side of the house, we suggest using an approved house shield to prevent soot from building up
on the side of the house.
● A vent must not be located where it will become plugged by snow or other material
Figure 7: Vent Termination
A:A Minimum 4’ clearance below or beside any door or window that opens. (This clearance may be reduced to
18
”
if using out-side air). We recommend the door or window be kept closed during operation. Minimum 1
’
clearance below or beside any window that does not open.
B:Minimum 1’ clearance above any door or window that opens
C: Minimum 2’ clearance from any adjacent building
D:Minimum 7’ clearance above any grade when adjacent to public walkways
E:Minimum 2’ clearance above any grass, plants, or other combustible materials.
F:Minimum 3’ clearance from any forced air intake of anyother appliance
G:Minimum 2’ clearance below eaves or overhangs
H:Minimum1’ clearance horizontally from combustible wall
X:Must be a minimum of 2’ above the roof
NOTE: Vent may not terminate in covered walkway or breeze- way.