Smeg WDI73121, Инструкция по эксплуатации

Страница: 7 / 24

EN
7
2.2 POSITIONING AND LEVELLING
1. Place the appliance in the
chosen position.
2. Level the appliance carefully
in all directions with the aid of
a spirit level, adjusting the
height of the feet if necessary.
Once done, fix the feet in
place with the locknuts pro-
vided.
The water intake and drain hoses can be fitted pointing to the left or right for effective installation.
Warning!

This operation must be carried out with care to prevent the washer-dryer from vibrating, moving or
generating excessive noise during use.

If the appliance is installed on a carpeted floor, take care to ensure that the openings in the bottom of
the washer-dryer are not obstructed.

Also check that during operation the washer-dryer is not resting against walls, kitchen units, etc.

The appliance must not be installed behind a door with lock, a sliding door, or a door with hinge on the oppo-
site side.
2.3 CONNECTING TO THE WATER SUPPLY
1. Check that the water supply pressure is in the following range:
0,05-0,9MPa . With
higher pressures, use a pressure reducer.
2. Connect the cold water supply hose ( blue screw collar) to the cold water tap with ¾
gas threaded connector, taking care to tighten firmly to prevent leaks. The water sup-
ply hose must not be kinked or crushed and must not be changed or cut. Threaded
connections must only be tightened by hand.
3. When appliances are supplied with hot water , the intake water temperature must not
exceed 60°C and the hose with red screw collar must be connected to the hot water supply tap.
Warning!

If the connection is made to new pipelines, or lines which have been out of use for a long time, allow a con-
siderable amount of water to flow out before connecting the intake hose. This prevents any sand or other dirt
from fouling the filters installed in the appliance to protect the water intake valves.

The new intake hose supplied with the appliance must be used, and the old water supply hose must not be
used.