Removal of transport bracket
The washing machine is fitted with a transport bracket to
avoid any possible damage during transport.
IMPORTANT: Before using the washing machine, the
transport bracket at the back MUST be removed.
1.
Unscrew the two screws “
A
” and the four screws “
B
”
with a flat screwdriver or a No. 8 hex nut box spanner.
2.
Remove the transport bracket.
3.
Replace the four outer screws “
B
” on the machine and
tighten them.
4.
Clip the two seals “
C
” supplied into the openings “
D
”
of the washing machine.
Note: do not forget to replace and tighten the four
outer screws.
GB 3
INSTALLATION
Adjust the feet
Install the washing machine on a level surface, near to
electrical, water and drain connections.
If the floor is uneven, adjust the feet (do not insert pieces
of wood, cardboard etc. under the feet):
1.
Loosen the locknut using the wrench provided.
2.
Adjust the height of the feet by hand.
3.
Retighten the locknut by turning it anti-clockwise.
Make sure that the feet are resting correctly on the
floor and that the washing machine is perfectly level
and stable (use a spirit level).
The washing machine can be installed in an area 40 cm wide
and 63 cm deep.
Note:
if you install the machine on thick carpet, adjust the
feet to ensure that there is sufficient space under the
machine for the air to circulate.
2
4
C
D
1\3
A
B
