Smeg ST8246U, Инструкция по эксплуатации

Страница: 37 / 50

USER INSTRUCTIONS
35
EN
EN
30
USER INSTRUCTION
6.2 Cleaning the water intake filter
Clean the water inlet fil er at regular intervals. After closing the delivery tap, unscrew
the ring nut (ref. A fig. 6-01) on the water inlet pipe (using a pair of pliers, if neces-
sary) and delicately clean the fil er, removing deposits or impurities.
Then fi mly fix the pipe by tightening the ring nut (ref. A fig. 6-01) (use a pair of pliers,
if necessary).
6.3 Cleaning the spray arms
The spray arms can be easily removed for periodic cleaning of the nozzles, to pre-
vent possible clogging. Wash them under running water (at room temperature) and
carefully replace them in their seats, checking that their rotary movement is in no
way impeded; if this is not the case, make sure they have been mounted properly.
Removing the spray arms
• To remove the upper spray arm (ref. A fig. 6-02), unscrew the locking ring (ref. B
fig. 6-02) by turning it clockwise. After cleaning, remount the spray arm in its seat
and tighten the locking ring by turning it anti-clockwise.
• To remove the orbital spray arm assembly (ref. A fig. 6-03), take hold of the lower
arm (ref. B fig. 6-03) and pull the orbital unit upward (see fig. 6-03).
After cleaning, remount the orbital spray arm in its seat and push it down slightly un-
til it clicks into place on the lower spray arm (see fig. 6-03). Then remount the lower
spray arm into its seat and push it down slightly until it click into place (see fig. 6-03).
Fig. 6-01
EN
31
A
USER INSTRUCTION
Fig. 6-02
Fig. 6-03
A
B
.
• • • • • • •
Fig. 5-02
Fig. 5-03