Smeg ST8246U, Инструкция по эксплуатации

Страница: 15 / 50

USER INSTRUCTIONS
13
EN
EN
12
USER INSTRUCTIONS
ff o g n i h c ti w S 8 . 2 . 2
e h t d n a p e e b tr o h s a s ti m e r e h s a w h si d e h t , m a r g o r p e h t f o d n e e h t t A indi-
cator lights of the fourth and fi fth program (ref. pr. 4, pr. 5 fi g. 2-04) fl ash.
Turn off the appliance by opening the door and pressing the on/off button (ref.
1 fi g. 2-02).
FIG. 2-04
If it is necessary to open the door during the washing cycle, the
program will be interrupted, the relative indicator light will continue to
fl ash and a beep will indicate that the cycle has not terminated. Wait
for about 1 minute before closing the door and continuing with the
program. When the door closes, the program will start from where it
was interrupted. This operation should be performed o nly if neces-
sary as it could cause irregular program performance.
S E H S I D E H T G N I V O M E R 4
˜˜˜
t s a el t a ti a w , m a r g o r p g ni h s a w e h t f o d n e e h t t A 20 minute before
removing the dishes in order to allow them to cool. To prevent any
water droplets on the upper rack from falling onto the dishes in the
lower rack, empty the lower rack fi rst and then the upper one.
2.2.9
symbols programs according to the models
2.3 Additional functions
2.3.1 Adjusting the water softener
(on some models only)
N.B.: a different washing program from soak must be used to make
the following adjustment.
Press and hold down the program delay button (ref. 12 fi g. 2-05) until the
preset value appears followed by a dot (normally
3.
). Release the button and
then press it again and again until the required value is displayed, as indicated
in the table (see tab. 2-03).
The 6 possible adjustment levels will appear in this sequence:
3., 4., 5., 0., 1., 2..
When the required value appears on the display, release the button; after 5
seconds the appliance automatically reverts to the program delay and the
adjustment is set to the chosen value.