Instructions for the installer
17
8. GAS CONNECTION
If the appliance is installed on an oven, you must avoid running the gas tube
round the back of the oven in order to avoid overheating.
Connection to the gas supply network can be made using a
rigid copper hose
or a
flexible steel hose
with a continuous wall and in compliance with the
guidelines established by the applicable standard.
To facilitate the connection, connector
A
on the back of the appliance can be
orientated laterally; loosen hexagonal nut
B
, twist connector
A
into the desired
position then retighten hexagonal nut
B
(it is sealed with a rubber gasket). Once
the operation is complete, check the hose fittings for leaks using a soapy
solution; never use a flame.
The cooker hob is preset for
natural gas G20
(2H)
-
G20/G25
(2E+)
at a pressure of 20 mbar
- 20/25 mbar
. For supplying it with
other types of gas, see chapter "9. ADAPTATION TO DIFFERENT TYPES OF
GAS". The gas inlet connection is threaded ½” external gas ISO 7-1
/ ISO
228-1 .
Connection with a rigid copper hose
: The
connection to the gas supply network must be made
in such a way that it does not cause stresses of any
type on the appliance.
The connection can be made using the adapter unit
D
with double cone, always inserting gasket
C
(provided) in between.
Connection with a flexible steel hose
: use only
continuous wall stainless steel hoses that comply
with the applicable standards, making sure to always
insert gasket
C
(provided) between connector
A
and
flexible hose
E
.
Installation with flexible hose must be carried out so that the length of the piping
does not exceed 2 metres when fully extended; make sure that the hoses do not
come into contact with moving parts and that they are not crushed in any way.
BE
BE
BE
