23
Steam extraction time setting (optional if installed Steam heat recovery (SHR+) phase
duration setting (optional if installed)
This is t he final phase of t he program w hich eliminat es t he
st eam creat ed during rinsing, prevent ing it from escaping
int o t he w ork environment .
If t he machine is opened w hile t his operat ion is being carried
out (not recommended), t he st eam heat recovery phase
st ops and is not resumed w hen t he machine is closed. The
current cycle is t herefore st opped permanent ly.
Durat ion: cust omisable
from 40 to 120 seconds
.
Service setting (for After-Sales Service only)
See informat ion on Smegt ech
7.3
Starting the peristaltic pumps – rapid filling of detergent and rinse aid delivery
circuit.
Perform after the parameter modification procedure explained in the previous point
Wit h t he dishw asher pow ered up and t he t ank full, press t he
on/ off
but t on for a few seconds; w hen ------ appears on t he
display, release t he but t on and press it again
quickly w ithin
0.5 seconds
.
The perist alt ic pumps cont inue t o operat e unt il t he same
but t on is pressed again.
The rinse aid and detergent symbol
lights flash alternately as long as the pumps are on
; bear in
mind t hat t he rinse aid perist alt ic pump fills t he circuit in
about 7 minut es, w hile for t he det ergent it only t akes 2
minut es. So draw only rinse aid from t he jerry cans (1 for t he
rinse aid and t he ot her for t he det ergent ) for t he first 5
minut es and t hen also t ake in det ergent for t he last 2.
On some models, t he message
“door”
(PCB self-diagnost ics on dishw asher closure) may
appear during t he set up procedure. To reset t he message, open t he dishw asher door and
close it again. If t he message persist s, cont act t he aft er-sales service.
