20
5) ELECTRICAL CONNECTIONS
The electrical connection must be made in
conformity with current rules and regulations.
Before making a connection, check that:
- The capacity and outlets of the electrical
installation are suitable for the maximum power
output of the appliance (see the information label
attached on the underside of the housing).
- The outlet or installation is provided with a ground
connection according to standards and provisions
currently in force. All responsibility is declined for
failure to comply with these provisions.
- If a power cord is not supplied with the appliance,
connect a cable with a suitable section to the
terminal board (see the table in paragraph 6)
keeping the ground wire longer than the lead
wires in conformity with the diagram in fig. 7.
When connection to the power circuit is made
through an outlet:
- Apply to power cable "C", if not provided, a
standard plug suitable for the load indicated on
the information label. Connect the wires as in the
diagram in fig. 7 taking care to observe the
responses listed below:
Letter L (phase) = brown cable;
Letter N (neutral) = blue cable;
Symbol
(earth) = yellow-green cable.
- The power cord must be placed in a way that it
does not reach an excess temperature of 75K in
any position.
- To connect, do not use adaptors or switches as
they may cause false contacts resulting in
dangerous overheating.
When connection is made directly to the power
circuit:
- Place a switch between the appliance and the
circuit of an appropriate size for the load of the
appliance and with a minimum aperture between
contacts of 3mm.
- Remember that the earth cable must not be
broken by the switch.
- As an alternative, the electrical connection may
also be protected by a high sensitivity differential
switch.
It is strongly recommended that the yellow-green
earth cable provided be connected to a good earth
installation.
WARNING: All of our appliances are designed
and manufactured according to European
standards EN 60 335-1 and EN 60 335-2-6 and
relative amendments.
This appliance satisfies the requirements of
European directives:
- CEE 89/336 + 92/31 + 93/68 concerning
electromagnetic compatibility.
- CEE 73/23 + 93/68 concerning electrical safety.
INSTALLATION
FIG. 7
