30
Instructions for the Installer
13.2 Positioning the oven
The appliance is designed for building-in to cabinets made from any heat-
resistant material. Comply with the dimensions shown in figures
1
,
2
,
and
3
. When installing under worktops, comply with the dimensions shown in
figure
1
-
3
. When installing under worktops incorporating combined hobs,
a gap of at least 110 mm must be left from any side wall, as shown in
figure
1
.
When installing in tall units, comply with the dimensions shown in figure
1
-
2
, bearing in mind that the top/rear of the unit must have an opening 80-
90 mm deep. Screw the 2 screws
A
into the inside of the frame (fig.
1
). For
installation under counter-top hobs, make sure that the rear/bottom of the
unit has an opening similar to that shown in figure
1
(ref.
B
). See the
instructions supplied with the hob for the relative positioning and fixing
procedures.
