74
Instructions for the user
11.
INSTALLING THE APPLIANCE
11.1 Electrical connection
The I.D. plate with technical data, serial number and brand name is
positioned visibly on the oven door frame.
The plate must not be removed.
The appliance must be electrically grounded in compliance with the
electrical system safety regulations.
If a fixed connection is being used it is necessary to fit the power line with
an omnipolar circuit breaker with a contact opening gap equal to or greater
than
3 mm
, in an easily accessible position close to the appliance.
If a plug and socket connection are being used make sure that the plug
and socket are compatible. Avoid use of adapters and shunts as these
could cause overheating and risk of burns.
Operation at 220-240 V~:
use a type
H05RR-F (3 x 1.5 mm
2
) or type
H05V2V2-F (3 x 1.5 mm
2
) three-wire
cable.
The earth wire (yellow-green) must be at least 20 mm longer than the
other wires at the end for connection to the appliance.
WARNING: THE VALUES INDICATED ABOVE REFER TO THE CROSS-
SECTION OF THE INTERNAL CONDUCTOR.
If the power supply cable has to be replaced, remove the rear casing by
undoing the screws as shown below. The cross-section of the power cable
must be at least 1.5 mm
2
(3 X 1.5 cable) and it must withstand
temperatures up to 90°C (H05V2V2-F). Make sure that the cables follow
the best possible route and use band clamps to fix them at the side of the
cabinet, to avoid any contact with the oven.
