65
Instructions for the Installer
14.2 Positioning the oven
The appliance is designed for building-in to cabinets made from any heat-
resistant material. Comply with the dimensions shown in figures 1, 2, and
3. When installing under worktops, comply with the dimensions shown in
figure 1-3. When installing under worktops incorporating combined hobs,
a gap of at least 110 mm must be left from any side wall, as shown in
figure 1. When installing in tall units, comply with the dimensions shown in
figure 1-2, bearing in mind that the top/rear of the unit must have an
opening 80-90 mm deep. Screw the 4 screws A into the inside of the frame
(fig. 1). For installation under counter-top hobs, make sure that the rear/
bottom of the unit has an opening similar to that shown in figure 1 (ref. B).
See the instructions supplied with the hob for the relative positioning and
fixing procedures.
