Smeg PL647GSA, Инструкция по эксплуатации

Страница: 39 / 42

User instructions
37
6. Troubleshooting
The dishwasher is capable of signalling a number of faults through the
simultaneous illumination of several indicator lights, with the following
meanings:
FAULT DESCRIPTION
E1
Acquastop failure
The anti-flooding system has been activated.
The system is tripped in case of water leaks.
Contact the after-sales service.
E2
Safety level
The system which limits the water level inside
the dishwasher has been tripped. Interrupt the
program and switch off the dishwasher. Switch
the dishwasher back on, program it again and
start the washing cycle. If the problem persists,
contact the after-sales service.
E3
Water heating malfunction
The water is not heated or the heating
parameters are not correct. Repeat the
washing program; if the problem persists,
contact the after-sales service.
E4
Water temperature monitoring malfunction
Interrupt the program and switch off the
dishwasher. Switch the dishwasher back on,
program it again and start the washing cycle. If
the problem persists, contact the after-sales
service.
E5
Water intake malfunction
The appliance does not take in water or does
not do so correctly. Check that the water
connections are correct, the water intake tap is
turned on and the filter is not fouled. If the
problem persists, contact the after-sales
service.
E6
Water pump-out malfunction
The appliance does not pump out the water or
does not do so correctly. Check that the drain
hose is not kinked or crushed and that the
siphon and filter are not fouled. If the problem
persists, contact the after-sales service.