35
Instructions for the installer
2. INSTALLATION
2.1 Electrical connection
Make sure the voltage and the cross-section of the power cord match
the specifications indicated on the identification plate positioned on the
frame of the oven door.
Do not remove this plate for any reason
.
The appliance must be connected to earth in compliance with electrical
system safety regulations.
If a plug and socket connection is being used make sure that the plug
and socket are compatible. Avoid use of adapters and shunts as these
could cause overheating and burns.
If a fixed connection is being used, fit the power line with an omnipolar
circuit breaker with a contact opening gap equal to or greater than
3
mm
, in an easily accessible position close to the appliance.
For operation on 220-240V
∼
:
use an
H05RR-F / H05RN-F type three-core cable
(3 x 1.5 mm
2
).
The end to be connected to the appliance
must be an earth wire (yellow-green) at
least 20 mm longer.
The manufacturer declines all responsibility
for damage to persons
or things caused by non-observance of the above prescriptions or by
interference with any part of the appliance.
