40
Instructions for the user
7.3
First use
At first use, or after a power failure, the oven display (DSP1), will show a
flashing
symbol. To start any cooking operation, the current time
must be set.
(For further information about setting or adjusting the current time, see
point "7.6 Secondary menu").
7.4
Selecting the function
To select a cooking function, turn PT2.
Then select the temperature required using knob PT1
7.4.1
Cooking with preset temperature
After selection of the function required, the oven will start the cooking
procedure at the preset temperature. Cooking itself is preceded by a
preheating stage (common to all functions) which allows the oven to
heat to the cooking temperature more quickly.
The
symbol flashes on the display (DSP1) to indicate that this stage is
in progress. When the preheating stage is over, the
symbol will remain
constantly on to indicate that the food can be placed inside the oven.
7.4.2
Changing the preset temperature
The temperature preset for each function can be changed to suit the user's
requirements.
At any time while cooking is in progress, turn PT1 in either direction to
increase or decrease the cooking temperature by 5 degrees at a time. PT1
can also be held in the left or right position to increase or decrease the
setting more quickly.
7.5
Programmed cooking procedures
7.5.1
Timed cooking with minute minder
From ON status (see point “7.2 Operating modes”), press PT1 once. The
display will show the
figures (constantly on) and the
symbol
(flashing). Turn PT1 to set the minutes of cooking (from 00:01 to 23:59). A
few seconds later, the
symbol will stop flashing, and the countdown will
start from that moment. Now you can also select the cooking function
required and wait for the buzzer to sound, indicating that the cooking time
is over.
Press PT1 once to stop the buzzer. You can now set an additional cooking
time by turning PT1, or return to display of the current time by pressing
PT1 twice.
Turn PT2 to the "0" symbol to switch the oven off completely.
The minute minder also works with no function set.
