User instructions
21
Warning:
during the initial phase of the wash program the spray arms cannot be
heard in operation because they start turning about 5 minutes after the
start. This is the normal wash cycle sequence.
END PROGRAM
At the end of the program the
DISPLAY
shows
“end”.
By pressing one of
the program buttons the dishwasher is ready to start a new cycle.
INTERRUPTING
A
PROGRAM
In order to interrupt a running program it is necessary:
to press the
START/PAUSE
for some seconds until when the
led
START/PAUSE
remains lit on (confirmation beep). At this point,
it is possible to start the cycle again, otherwise:
TO CHANGE A PROGRAM
To change the running program it is necessary:
to interrupt the running program (see “
I
NTERRUPTING A PROGRAM
”);
select the new program;
to press again the
START/PAUSE
button
to make start the new
program.
STOPPING A PROGRAM
To cancel a program which is running:
Interrupt the program (see "
INTERRUPTING A PROGRAM
")
Press the
START/PAUSE
button
and hold it down; the
display will show
"P0"
and the dishwasher will immediately
switch to the end of the cycle and drain the tank (during this
process, the
"START/PAUSE
led
will flash). When the drain
procedure ends, the end of cycle
"End"
message appears on
the display.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “
S
TARTING THE PROGRAM
”. The program will resume from the
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program will
start about 60 seconds later.
