User instructions
16
To set the delay once the program has started
, proceed as follows.
If the program you wish to carry out is the same as the one already in progress:
•
press
the
START/PAUSE
button
(4)
for a few seconds, until the
PROGRAM PHASES
lights
(8)
come on;
•
annul the program in progress (see relative section) and wait for the cycle to come to an end;
•
select the program again;
•
select the delay required;
•
press
the
START/PAUSE
button
(4)
to start the new program.
If the program you wish to carry out is different from the one already in progress:
•
press
the
START/PAUSE
button
(4)
for a few seconds, until the
PROGRAM PHASES
lights
(8)
come on;
•
change the program;
•
select the delay required;
•
press the
START/PAUSE
button
(4)
to start the new program. The dishwahser will pump out
the water and restart with the delay set and the new program.
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
•
Always try to run the dishwasher
fully loaded
.
•
Do not wash the dishes in running water.
•
Use the washing program that is
most appropriate
for each type of load.
•
Do not carry out any preliminary rinsing.
•
If available, connect the dishwasher to a hot water supply up to 60°C.
•
When possible,
skip the drying cycle
by leaving the door open when the washing cycle is
complete; the air and the residual heat will dry the dishes perfectly.
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the environment. To avoid
using excessive amounts of detergent and to save on electricity, observe the following:
•
separate
the more delicate items from dishes that are more resistant to aggressive detergents
and high temperatures;
•
do not pour
the detergent directly on the dishes.
