Smeg LBS65, Руководство пользователя

Страница: 3 / 12

3 - EN
2 Installation
Removing packaging
reinforcement
Tilt the machine to remove the packaging
reinforcement. Remove the packaging
reinforcement by pulling the ribbon.
Opening the transportation locks
A
Transportation safety bolts must
be removed before operating the
washing machine! Otherwise, the
machine will be damaged!
1. Loosen all the bolts with a spanner
until they rotate freely (“C”)
2. Remove transportation safety bolts
by turning them gently.
3. Fit the covers (supplied in the bag
with the Operation Manual) into the
holes on the rear panel. (“P”)
C
Keep the transportation safety bolts
in a safe place to reuse when the
washing machine needs to be moved
again in the future.
C
Never move the appliance without
the transportation safety bolts
properly fixed in place!
Adjusting the feet
A
Do not use any tools to loosen the
lock nuts. Otherwise, they can be
damaged.
1. Manually (by hand) loosen the lock
nuts on the feet.
2. Adjust them until the machine stands
level and firmly.
3. Important: Tighten all lock nuts up
again.
Connecting to the water supply.
Important:
• The water supply pressure required
to run the machine must be 1-10 bar
(0,1 – 1 MPa).
• Connect the special hoses supplied
with the machine to the water intake
valves on the machine.
• If you are going to use your double
water-inlet machine as a single (cold)
water-inlet unit, you must install the
stopper*, supplied with your machine
to the hot water valve.
• If you want to use both water inlets
of the product, you can connect the
hot water hose after removing the
stopper and gasket group from the
hot water valve.
* Applies for the products supplied with a
blind stopper group.
• Models with a single water inlet
should not be connected to the hot
water tap.
When returning the appliance to its place
after maintenance or cleaning, care should
be taken not to fold, squeeze or block the
hoses.
Connecting to the drain
The water discharge hose can be attached
to the edge of a washbasin or bathtub. The
drain hose should be firmly fitted into the
drain as to not get out of its housing.
Important:
• The end of the drain hose must be
directly connected to the wastewater
drain or to the washbasin.
• The hose should be attached to a
height of at least 40 cm, and 100 cm
at most.
• In case the hose is elevated after
laying it on the floor level or close
to the ground (less than 40 cm
above the ground), water discharge
becomes more difficult and the
laundry may come out wet.
• The hose should be pushed into the
drainage for more than 15 cm. If it is