Smeg LB107, Инструкция по эксплуатации

Страница: 5 / 28

155620
In removing the wrapping be careful not to damage the
appliance with a sharp object.
Before connecting the appliance, let it warm up to room
temperature (wait for two hours).
• Our appliances are packed in environmentally friendly
materials which may be recycled, deposited or decomposed
without any threat to the environment.
• To this end all wrappings are marked accordingly.
• Move the pipes.
• Loosen screws A at the rear of the machine (Fig. 1).
• Remove the brackets B (Fig. 1) and slide them into the groove
on the blocking rod (Fig. 2) - the right one should be turned
around.
• Use the brackets to rotate blocking rods for 90° and pull them
out.
• Close the openings with attached plastic pegs.
Save transport brackets for eventual later use.Save the transport
brackets for eventual later use.
Be sure to remove the transport brackets prior fi rst
use, otherwise the appliance may be permanently
damaged. In such cases the warranty conditions are
void.
Fig. 1 Fig. 2
• Put the appliance in horizontal position by turning the
adjustable legs.
The legs are adjustable up to +/- 1 cm.
After the adjustment tighten the nuts fi rmly (A) - towards
the bottom of the machine!
Vibrations, moving of the appliance and loud operation
due to incorrect setting of the adjustable feet shall not
be covered by this warranty.
The appliance should be placed on a surface with
concrete base; the surface should be dry and clean in
order to prevent slipping. The adjustable feet should
also be cleaned before installation.
Package removal Package removal
Removal of transport
brackets Removal of transport
brackets
Leveling the appliance Leveling the appliance
5
Installation and connection