Smeg KSEIL90X1, Инструкция по монтажу и эксплуатации, Страница: 6 / 8

12
the hood with two supplied screws
4. Put the metal filter back into place.
To replace the carbon filter - Fig. 3:
1. Disconnect the hood from the electricity.
2. Remove the metal filters.
3. Remove the old carbon filter and replace
it.
4. Put the metal filter back into place.
Cleaning
To clean the outside of the hood use a cloth
moistened with denatured alcohol or neutral
liquid detergents. Never use products
containing abrasive.
Wipe brushed stainless steel in the same
direction as the brushing to avoid scratching.
Attention
Failure to observe the instructions for
cleaning the appliance and changing and
cleaning the filters may cause fires.
Therefore, we recommend observing these
instructions.
Replacing the lamp - Fig. 4
1. Disconnect the hood from the electricity.
2. Remove the screw that fix the lamp cover.
3. Remove the faulty lamp.
4. Replace the faulty lamp with a new PL
lamp 11Watt max (for Wall model) or PL
9Watt max (for Ceiling model).
5. Refit the lamp cover and fix it with its
screw.
Before calling for repair service because
the hood fails to light up, make sure the
lamps are well inserted.
Warning!
— The hood cannot be connected to flues of
other appliances that run on energy
sources other than electricity.
— When the hood is used at the same time
of other appliances that run on energy
sources other than electricity, provision
must be made for an adequate supply of
air.
— No food must be cooked flambé
GB
To remove the metal grease filter - Fig. 2:
1. Disconnect the hood from the electricity.
2. a - push toward the centre
b - pull downwards.
Carry out the above steps in reverse order to
put the filters back after having washed
them.
Carbon filter
(“recirculation mode only”, see next pages)
The carbon filter cannot be washed nor
regenerated.
Hood featuring control panel with
keypad
The carbon filter should be replaced every 6
months under normal use.
Hood with electronic control panel
The carbon filter should be replaced every 6
months under normal use and anyhow
whenever the carbon filter saturation led
indicates the saturation of the filter.
This LED indicates carbon filter needs to be
replaced.
This led flashes to warn you that the carbon
filter must be replaced.
This must be done after approximately 160
hours of use.
Read the instructions reported below for
replacing the carbon filter.
Once you have replaced the carbon filter,
press button A and button B together for
about two seconds (see page 11) until you
hear the acoustic signal (beep).
The carbon filter saturation led C will now
stop flashing.
N.B.: the carbon filter saturation led will also
flash even if the hood is used in the
exhausting version (i.e. without carbon filter).
To stop the led flashing, press the two buttons
A and B as described above.
To fit the carbon filter - Fig. 3:
1. Disconnect the hood from the electricity.
2. Remove the metal filters.
3. Fit the carbon filter and fix it to the body of