Smeg KSEIL90X1, Инструкция по монтажу и эксплуатации, Страница: 5 / 8

11
Control panel with keypad
- Fig. 1 -
a. "ON" indicator light
b. Light ON-OFF button
c. Motor OFF button
d. e. f. Motor speed buttons
speed 1 (d.), speed 2 (e.), speed 3 (f.)
Electronic control panel
A –Motor OFF button
B –On button and motor speed selection
button 1 - 2 - 3 - 1 - 2 - . . . .
E –Speed 1 LED
F –Speed 2 LED and metal grease filter
saturation LED (flashes)
C –Speed 3 LED and carbon filter saturation
LED (flashes)
D –Intensive speed LED
G –Intensive speed ON switch This speed
should be used when the concentration
of cooking fumes or odours is
particularly strong (for example when
frying, cooking fish etc.). The fast speed
will run for about 5 minutes and then
return to the speed previously set
automatically (1, 2 or 3), or switch off if
no speed was selected. To turn off the
fast speed, before the end of the 5
minutes, press button A or button B.
H –OFF lamp button
I
–ON lamp button
If the hood fails to operate correctly, briefly
disconnect it from the mains power supply
for almost 5 sec. by pulling out the plug.
Then plug it in again and try once more
before contacting the Technical Assistance
Service.
Use of the hood
It is advisable to switch on the extractor
hood a few minutes before starting cooking
and then to leave it running for approximately
5 minutes afterwards to ensure that all odours
are extracted.
Maintenance
Before performing any maintenance
operation, isolate the hood from the electrical
supply by switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected
through a plug and socket, then the plug
must be removed from the socket.
Metal grease filter
The metal grease filter lasts forever and
must be washed either by hand or in the
dishwasher (65°C) with suitable detergents.
Let the filter dry without damaging it before
putting it back into place.
When washed in a dish washer, the grease
filter may discolour slightly, but this does not
affect its filtering capacity.
Hood featuring control panel with
keypad
The grease filters must be washed at least
once a month.
Hood with electronic control panel
The metal grease filters must be washed at
least once a month and anyhow whenever
the metal grease filter saturation led
(Speed 2 LED) indicates the saturation of
the filter.
This LED warns you when the metal grease
filter needs to be cleaned.
This LED flashes to warn you that the metal
grease filters must be cleaned.
Generally, these must be cleaned after 40
hours of use.
Read the maintenance instructions provided
for the grease filters.
Once the grease filters have been cleaned,
press button A and button H at the same
time (see page 11) for about two seconds
until you hear the acoustic signal (beep):
the grease filter saturation led F will now
stop flashing.
GB
B E F C D G
H
I
A