27
10
CHOSING THE PROGRAM
Scrolling through the programs available displays first the program name (in English) and hen the
number (P1, P2….. etc.) followed by the duration.
PROGRAM
TYPE OF DIRT
DURATION (*)
DISHES Short
P1 Lightly soiled plates
1 min
Dishes Medium
P2 Normally soiled plates
1 min 30s
DISHES Long
P3 Heavily soiled plates
2 min 30s
CUSTOM Program User
P4 Customisable (see "set-up information")
1- 10 min
Cutlery
P5 Intensive programm with 70°C washing
4 min 10s
Utensils
P6
Intensive programm for heavily soiled
kitchen utensil
7 min 10s
GLASS Short
P7 Dirty soiled glasses
1 min
(*) The cycle duration stated above is guaranteed if the water intake temperature is as stated and
recommended in the "TECHNICAL DATA" table, and in all cases refers to the first cycle performed.
For repeated cycles, operating conditions may vary from installation to installation. If the
dishwasher is supplied with cold water, the cycle duration might increase depending on the intake
water temperature and the "thermostop" setting.
Power blackouts.
If the dishwasher is open when power is restored, the display will read “
°
t
” and the
heating element will remain off, to prevent the risk of burns to the user.
Close the dishwasher to resume heating the water in the tank.
Enabling/disabling the program name on the display
The display shows the program number P1, P2, P3 and name, Glass, Dishes, Cutlery etc. by default.
You can choose not to display the name of the program. In this case, only P1, P2, P3 etc. will be
shown on the display.
The procedure must be carried out with the machine switched off but powered.
Press and hold down the start / pause button.
When the vertical lines ||||| appear on the display, release the start / pause button and then
press it again immediately.
The procedure is complete; there is no audible or visual confirmation.
It is possible to check if the procedure has been carried out correctly when the machine is
switched on again.
